• The Controsense Series
• The PDA Series Amplifier Modules
• The DMS1 H Hours Run Monitor

Process monitors for display recording alarm and control.

Controsense 125S
Frequency rate and speed monitors with voltage, (0-10V) loop current (4-20mA) or dual relay outputs and multi sensor input amplifiers. Available for 115/230V AC or 24V AC.

Controsense 130S
A range of frequency or pulse sensing monitors designed for mobile, portable or vehicle applications. Models available with voltage loop current and relay outputs. Standard supply voltages 12 or 24V DC.

Controsense 125A
Voltage (0-10V) and loop current (4-20mA) monitors with options of dual relay or analogue voltage or current outputs. Available for 115/230V AC or 24V DC.

Controsense 125T
Repetitive timing modules suitable for calibration and control of conveyor times, Baking Ovens, etc. Available for 115/230V AC or 24V AC.

Controsense 125C
Count based controllers with dual relay set points on input pulse rate or count input. Available for 115/230V AC or 24V AC.

Controsense 130C
Counting controllers with dual relay outputs of rate or count input. Standard supply voltages of 12 or 24 Volts DC.

Controsense 130CS
Servo controller systems suitable for variable speed gearboxes or other devices providing a pulse feedback signal. Provides up to 8 pre-set speeds. Supply voltages of 12V or 24V DC.

Controsense 125SD
Slip detection control system designed for use with fork lift truck clamps. Gives optimum gripping force for drums or reels. Supply voltages of 12V or 24V DC.

Controsense Programming:
Controsense modules are normally delivered calibrated to your requirements. However, a low cost plug-in programmer LCD-DIS is available which enables on-site adjustments to be easily carried out.

Program information is entered on three pushbuttons and the program and process data is viewed on the integral LCD display.

Plug in Amplifiers for sensors and isolated contacts.

The PDA series modules are plug in amplifiers designed to enable magnetic and inductive proximity sensors and isolated low voltage contacts to interface directly with a wide range of equipment. Important features are supply isolation and integral sensor power supply.

Applications include; Limit switches, Interlocks, Motion detectors, Interface to electronic systems, Low current metallic contact detection.

Versions with integrated timers are also available.

Features Include:

• Integral power supply allows use of low voltage sensors
• Isolated relay modules have insulation voltage up to 3000V DC
• Logic outputs for direct connection to electronic circuitry
• Low Voltage / Current inputs for mechanical & electronic sensors

The DMS1 H is fitted with a pulse output signal which operates from the AC mains supply at 100 pulses per second. When this feature is used with the DMS CT and the pulse signal is 'gated' with a suitable switch the interval counter will increment whenever the switch is closed.

This DMS1H system may be used to monitor the ON time of electronically operated loads which switch ON & OFF at unpredictable times.

This type of system has applications for example in energy monitoring where the ON time of a heating boiler needs to be known for costing purposes.